Filter

Please select

123

10 07, 2021

Fakuma 2021

Fakuma 2021

Cavity Eye Hungary Kft. together with the German representative participate at the Fakuma fair in Friedrichshafen on 12-16 October 2021. Our visitors and customers can meet our colleagues at Halle A5 - Stand A5-5126.

09 15, 2021

Equiplast 2021

Equiplast 2021

Cavity Eye Hungary Kft. together with the Spanish representative participate at the Equiplast fair in Barcelona on 14-17 September 2021. Our visitors and customers can meet our colleagues at Gran Via, Hall 3, Level 0, Street F, Stand 53.

09 16, 2021

Change of residence!

Change of residence!

We would like to infomr you that our billing address changed. Our VAT number, mailing and shipping address stayed the same as before.



Our new billing address:

Templom tér 19.

2040 Budaörs



Our mailing/shipping address:

Mindszenti krt. 27/A

6000 Kecskemét

08 27, 2021

Introducing our new UTP cables!

Introducing our new UTP cables!

We offer new UTP cable series to our customers.

09 21, 2021

Learn about the sensor installation process!

Learn about the sensor installation process!

In our new video we show how to install the pressure sensors into the injection mould, starting from the preparation and check of the mould and finishing with the testing.

08 03, 2021

KUTENO 2021

KUTENO 2021

A Cavity Eye Hungary Kft. and CAVITY EYE Deutschland GmbhH will be an exhibitor at KUTENO. The fair will take place from 7 to 9 September 2021 in Rheda-Wiedenbrück, Germany. You can meet our representatives at stand Halle 1 A11-1.

06 17, 2021

Again on the frontpage of Polimerek magazine!

Again on the frontpage of Polimerek magazine!

In our new article, which was published in the Hungarian Polimerek magazine, we report on some of our recent projects that were successfully completed despite the difficulties caused by the pandemic. We also share some of our future plans too.

03 10, 2021

Cavity Eye interview

Cavity Eye interview

A new article from Cavity Eye was published in Polimerek, the magazine of Hungarian plastics and rubber industries. It is an interview with András Szűcs PhD (CTO) about the traditional injection moulding trainings of Cavity Eye and about the planned workshop system.